Stealthcraft ATB 16x60 with Merc 15hp

[Jdecoudres]

2013 Stealthcraft ATB boat, 16x60 with a 4 stroke mercury 15hp electric start.

TROLLING MOTOR NOT INCLUDED!!!!!

Eric Hornung fiberglass veil 

Concave Transom and Bottom For Easy Motoring and Improved Turning

Integrated Rolled-Edge Rails with 4 CutOut Handles 2 In Front, 2 in Back   Stealth Bottom Full GelCoat Full Keel Guard Bow Protection, so excess wear will not happen at point of eye bow & trailer   Sawyer square top oars with matching wrap to the boat 6" extra long oar-locks for lots of rowing height options 4 UHMW Spacers Included For Extra Adustment  "Switch Rowing Oar Blocks" 8 Oar Spots to Move Oarlocks, allows boat to be rowed front or back Stealth Super Strong Oar Blocks Counter Sunk For Flush Bolting DiamondPlate OarBlock Washers on the Outside of the Hull For Extra Durability     River Larry electric wrinch with three different switches positioned throughout the boat 70IB pyramid  anchor   Rear Deck With Cut Out So Gas Tank and Battery Will Fit In, Also Cut Out so Person Can Fit Under Deck Into Casting Brace, Casting Brace Pieces Laminating In for Flush Mount No Catch Casting, Casting Braces Are Removable, 2 CupHolders in Casting Brace, 2 CupHolders in Rear Deck, Rear Deck Edge Finish Trimmed For Fit and Finish Rear Level Casting Decks with Pedestal Laminated in  Stealth Grande Rowing Box Aft, With full Hinged Lid Stainless Riveted The Whole Way Rower Box on Front Deck With Laminated Casting Braces , Casting Brace has Solid Screw In Screw Out With 25" Poles and Molded Casting Brace, Flush Mount Rowers Cup Holder Rod holders on both sides of the boat x8--10' with Tackle Tray Above, Rod Holders Has Finsh Trim Edge To Protect Rods, Tackle Tray has Plenty of Room For Tackle Etc Removable Rod Holders Set at Customers Preference For End of Rod Front Bow Deck with Removable Seat For Flush Mount No Snags Seating, Storage Opnening   Low Back Rowing Seat, Removable Rear Seat, Pedestal Front Seat Glassed in wire runner from front to back for easy no catch wiring 10 Cup Holders/2 Flush mount floor cup-holders   MK 160 On-Board Batt. Charger 1 Bank 6 amp Installed, Plug in Walk Away and Charge 6 LED Exterior Lights (head lights in front) with Wired Switch    24" Interior Led Lights (under tackle trays, near motor well etc) W/ Fused Switch x 2 12 Volt Power Point (@ rowers station, rear motor area, etc., stainless steel)   Galvanized Trailer with Torision Suspension, Jack, Adjustable Winch, Knot Sense Bearings   G2 Boat Buckle Tie Down Strap, ratcheting Diamond Plate Anchor Nest Installed on the Trailer Supra Roller System For Trailer   Boat cover.   Transom has been beefed up to accept bigger motors as i had a 40hp yamaha on there.  you can stand up there and sight fish no problem.  Here is links to the exact boat from the factory.  jeremydecoudres@gmail.com 620.222.5940 $13500

[Jdecoudres]

sold