How-to-steps ( Wd40 )

[Jeremy Hunt]

WD40

Recipe

Hook: Tiemco 2487 size 16-24

Thread:UTC 70 Brown

Tail: Mallard flank or partridge

Wingcase: Mallard flank or partridge

Thorax: Prism dubbing

Tying Instructions:

Step 1.

Tie the thread up at the eye and cut the tag end off.

Step 2.

I wanted to show how to tie in the mallard and guage the tail the length you want it. This should be fairly long because your going to use it for the wing case and bypass a step. When you tie this in make sure the tips are fairly even. Now make a few turns to lock it in. Now pull back by the tips and measure the length Then wrap back until you get just past the bend keeping each wrap side-by-side.

Step 3.

Now advance the thread back up still keeping the wraps side by side. Notice where I stopped with my thread.

Step 4.

Attach some dubbing to the thread. You only need enough to make three turns around. Keep the ball of dubbing fairly small.

Step 5.

The only thing you need to pay attention to when doing this step is to make sure when you go to pull the mallard over for the wing case that you don’t twist the mallard. You’ll notice when you go to pull it over you’ll kind of bunch it up like its been grouped together. What you’ll want to do is flatten the mallard out and then fold it over and tie it down.

Step 6.

Trim off the excess off and make a nice thread head. Just don't over do it.

Whip finish the fly and glue the eye. Completed fly.

[catman]

Thanks, I was just looking for uses for my Mallard flank for tying, got any more uses for Mallard flank Jeremy?