Help on replacing outboard rigging loom

[fowlthing]

My current  rigging loom is not connected to the motor.  It seems to me to allow some water into the boat . (2011 Ranger 522, Yamaha 250) I also want to run the ethernet cable from the motor to my graph.

The current bundle looks as full as possible.  I helped a friend fish one of these cables down his loom and it was very difficult. 

Suggestions on a split loom, or some type of cable cover. 

I have seen one with a zipper on Amazon, and one from McMaster-Carr that is a cable wire wrap.

Suggestions?  

Thanks for any help

[fishinwrench]

TH Marine, at one time, made a neoprene rigging cover with a Velcro closure.   Alot of guys hated them because they only lasted a couple years in the elements.....but they weren't overly expensive to refresh periodically.    I tried to search for one but it didn't pop right up....so they may have quit offering them.  

I hate the zippered ones, they look worse than bundling/covering with 4 pounds of electric tape, plus you can't cut to size without destroying the stupid zipper. And after a year the zipper doesn't work anymore anyway.....and you have to just cut it off when replacing control cables, fuel/oil hose, ect.

[fowlthing]

Thanks this is good info.  I May try the one from McMaster  it is neoprene and has Velcro closure. 
 

thanks again