SOLD - Stealthcraft 16x54 ATB with 20hp Merc

[N9BOW]

I am selling (trades considered) my 16ft Stealthcraft to buy an 18ft model power sled or Xtream or Topwater boat w/Jet transom.
the boat was made and delivery taken December 2015. She is a bit over a year old and has only been fished a few times (I get down to the White River a few times a year) I decided I want a bit bigger boat.

Shes in excellent shape, the motor is just at the 20hr mark. This is available for viewing in Flippin, just get with me and I can arrange a time to look at it or take it out.

$12,550.00   reduced $11,800.00

Will trade for newer Xtream or Topwater Jet

 

BOAT

2015 16' x 54" Power Drifter ATB

16' Down the Center, 25" Oarlocks 20" lowest Side

Concave Transom and Bottom For Easy Motoring and Improved Turning

Integrated Rolled-Edge Rails with 4 CutOut Handles 2 In Front, 2 in Back

BOAT BOTTOM

Stealth Bottom Full GelCoat With Teflon Additive Bottom

Color Black

Full Keel Guard Bow Protection, so excess wear will not happen at point of eye bow & trailer

OARS and OarLocks

Carlisle Composite Oars with Composite Shafts 9'

6" extra long oar-locks for lots of rowing height options

4 UHMW Spacers Included For Extra Adustment

"Switch Rowing Oar Blocks" 8 Oar Spots to Move Oarlocks, allows boat to be rowed front or back

Stealth Super Strong Oar Blocks Counter Sunk For Flush Bolting

DiamondPlate OarBlock Washers on the Outside of the Hull For Extra Durability

ANCHOR SYSTEM

Dierks Front Bow Anchor System,  3 Pulleys and Side Mount

Anchor Rope Holder

35' Drift Boat Anchor Rope With 3" Galv. Quick Link Connector

35 pound 4 sided pyramid anchor

INTERIOR OPTIONS

Rear Deck With Cut Out So Gas Tank and Battery Will Fit In, Also Cut Out so Person Can

Fit Under Deck Into Casting Brace, Casting Brace Pieces Laminating In for Flush Mount

No Catch Casting, Casting Braces Are Removable, 2 CupHolders in Casting Brace,

2 CupHolders in Rear Deck, Rear Deck Edge Finish Trimmed For Fit and Finish

Rear Level Casting Decks with Pedestal Laminated in

Rower Box on Front Deck With Laminated Casting Braces , Casting Brace has Solid Screw In

Screw Out With 25" Poles and Molded Casting Brace, Flush Mount Rowers Cup Holder

Port Side Rod Holders x4--10' with Tackle Tray Above, Rod Holders Has Finsh Trim Edge

To Protect Rods, Tackle Tray has Plenty of Room For Tackle Etc

Removable Rod Holders Set at Customers Preference For End of Rod

Front Bow Deck with Removable Seat For Flush Mount No Snags Seating, Storage Opnening

UnderNeth Boat With Finish Trimmed Opening

Low Back Rowing Seat, Removable Rear Seat, Pedestal Front Seat

Glassed in wire runner from front to back for easy no catch wiring

10 Cup Holders/2 Flush mount floor cup-holders Newly purchased not installed trolling motor mount by Stealthcraft made to fit ATB

TRAILER

Galvanized Trailer with Torision Suspension, Jack, Adjustable Winch, Knot Sense Bearings

1100# Trailer Winch , Galvanized 13" Tires

Spare Tire Installed

LED Trailer Lights Installed

Transom Savor For Motors Up to 40hp Saves Shock on Boat and Motor

G2 Boat Buckle Tie Down Strap, ratcheting

Diamond Plate Anchor Nest Installed on the Trailer

Supra Roller System For Trailer

INTERIOR DESIGN OPTIONS

Starboard Side Tackle Tray w/3 rod holder set (Bigger Rod Tubes) at Customer's Pref. 9-11'

Medium Hatch Aluminum Under Front Deck

Grande Aluminum Hatch For Battery Maintence on Rear Deck - Custom Painted With Boat

Yeti Cooler Strapped Down

Stealth Squares (Black) False Floor In Front  of Rower Seat- Custom Cut out one Piece

Upgraded Taco Marine Rod Holders With Bunge

Interior Hand Bilge Pump

EXTERIOR FINISH OPTIONS

White Gel Coat Exterior / Standard Grey Interior Black/Yeti Blue

ANCHOR SYSTEM OPTIONS:

Power Winch Support -Glassed in Along with Special Pulley on

Dierks Arm to Properly Coil Rope on Power Winch

Corded Power Winch Anchor Switch

Minn Kota Power Winch Installed with 3 Switches

Electrical Options:

MK 160 On-Board Batt. Charger 1 Bank 6 amp Installed, Plug in Walk Away and Charge

3 LED Exterior Lights (head lights in front) with Wired Switch

LED Navigation System Red/Green Led + Rear Post

24" Interior Led Lights (under tackle trays, near motor well etc) W/ Fused Switch x 2

12 Volt Power Point (@ rowers station, rear motor area, etc., stainless steel)

Interstate Deep Cycle Battery With Battery Box and Strap Mount in Rowers Box/Bow

Oar Upgrades:

Sawyer Composite Oars Black Roped and Stoped With Duramax Blades

Motor and Motor Upgrades:

Mercury 20 Electric Start Tilt and Trim

[WoundedOne]

 Eric What.. You must be gettin ready to get that new Topwater.

[Ham]

You might put a flyer up st the fly fishing shops. The fly guys should snap that up

[N9BOW]

1 hour ago, WoundedOne said:

 Eric What.. You must be gettin ready to get that new Topwater.

Actually gonna stay with stealthcraft.. just want to get a jet sled so I can go even skinnier waters. 

 

[N9BOW]

1 minute ago, Ham said:

You might put a flyer up st the fly fishing shops. The fly guys should snap that up

Yeah I will eventually make the rounds to the shops. Just got back to Iowa so it will be another month or two till I'm down there again. Spread the word if you wouldn't mind. Shes a sweet ride!

[WoundedOne]

10 minutes ago, N9BOW said:

Actually gonna stay with stealthcraft.. just want to get a jet sled so I can go even skinnier waters. 

 

That even better. It is a sweet boat. Cant wait to try out the new one someday with ya 

[N9BOW]

4 hours ago, WoundedOne said:

That even better. It is a sweet boat. Cant wait to try out the new one someday with ya 

Absolutely!

[fishinwrench]

Slick rig !    

Mighty pricey.... But nice.  

[Lancer09]

If I was in the market for a boat I'd be looking at one of them stealthcrafts. Great boat..

 

[N9BOW]

41 minutes ago, Lancer09 said:

If I was in the market for a boat I'd be looking at one of them stealthcrafts. Great boat..

 

They are terrific! just put in my specs for a sled.